Amtrol WELL-X1 Manuel d'utilisateur télécharger pdf (Page 9)

8. STARTUP & ADJUSTMENT

1. After plumbing and wiring are complete, close the

service valve to allow startup without pressurizing

the entire plumbing system. If a service valve was not

installed, close all ﬁxtures in the home. Ensure the

bottom drain is closed.

2. Restore power to the Well-X1

™

by turning on the

breaker and electrical service switch (if installed). The

display will illuminate.

3. The display will read "88" to test the display illumination,

then a number identifying the control type (i.e. 07). This

number is for factory use and may vary by model and

manufacture date.

4. After a slight pause, the pump will start and the system

pressure will be displayed. This number will increase

as the pump runs and the tank ﬁlls.

Note: Some jet pumps may be difﬁcult to prime,

resulting in the low water cut-off activating if pressure

will not build above 10 psig. Depressing the s arrow

will temporarily override the low water cut-off to allow

proper priming.

DISPLAY

SYSTEM

FROM

WELL

SERVICE

VALVE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Amtrol WELL-X1 Manuel d'utilisateur Page 9