BOILER MATETMTOP-DOWNINDIRECT-FIRED WATER HEATERS WITHTOP-MOUNTED COILThe heat transfer medium should be water. If any product other than water is use
-11-The BOILER MATE™ is intended to provide a tank service life ofmany years. Components, however, may be subject to failuresthat require service. F
-12-RESIDENTIAL BOILER MATE™ CLASSIC(TD-7Z and TD-41Z)ELECTROCUTION HAZARD.THE BOILER MATE™ MUSTBE ELECTRICALLY GROUNDED.NOTES:1. THE BOILER MATE™ MUS
-13-PROBLEM CAUSE SOLUTION1. No hot water at faucet. 1.Boiler does not operate. 1.a.Press reset button on boiler.b.Check main cut-off switch.c.Check
-14-DATE SERVICE PERFORMED COMMENTS CONTRACTOR9. SERVICE RECORD
AMTROL®BOILERMATE™CLASSIC AND TOP-DOWN™ LIMITED PRODUCT WARRANTYThis Warranty cannot be transferred - it is extended only to the original Purchaser or
West Warwick, Rhode Island 02893Part #: 9040-628 REV B (7/04)-16-
-2-1. GENERAL SAFETY INFORMATION...32. PRE-INSTALLATION CHECKLIST..
-3-IMPORTANT GENERAL SAFETY INFORMATION - ADDITIONAL SPECIFIC SAFETY ALERTSAPPEAR IN THE FOLLOWING INSTRUCTIONSEXPLOSION HAZARD: DO NOT INSTALL TO A
-4-jTHIS PRODUCT MUST BE INSTALLED ANDMAINTAINED BY A LICENSED PROFESSIONAL. IN ADDITIONTO THE INSTRUCTIONS IN THIS MANUAL, FOLLOW ALLAPPLICABLE LOCA
-5-TD-7Z, TD-41Z, TD-7ZDW, TD-41ZDWCOMPONENTS CHECKLIST The following is a checklist of components required for proper installation of these BOILER MA
-6-A. General Installation Requirements1. Do not "short circuit" the boilerDo not connect boiler supply and return lines to the samesection
-7-B. PIPINGPIPING SHOULD BE ACCOMPLISHED WITH UNIONS.Step 1 - Locate the BOILER MATE™ near boiler.Step 2 - Connect the cold water piping.a. Shut off
-8-Step 5 - Connect boiler supply pipe. Figure 1.a. Shut off the cold water supply valve to the boiler, anddrain it using a hose attached to the drain
-9-the service switch).c. Switch off the branch circuit breaker.Step 2 - Remove electrical box cover.Step 3 - Remove existing wire from boiler aquasta
Commentaires sur ces manuels